Freightliner No Throttle Response I Am Working On A With A Series 60 Detroit It Looses All
Since you have no throttle response or sluggish throttle response, this could be fuel system related such as at leaks or restrictions between the fuel tank in the pump or a fuel supply. Use the throttle to accelerate to 65 leaving the cruise on. I popped the brakes on & off and got the throttle to respond for a few seconds then back to no response.
I am working on a Freightliner with a series 60 Detroit. It looses all
This could be caused by the coolant level being below the sensor or a potential issue with the sensor or wiring resulting in biased readings. If the engine will start and run smoothly but has no response from the throttle pedal, i would take a very close look at the wiring and connector pins between your throttle pedal and the engine. Although this fault could potentially lead to a shut.
Truck starts and idle just fine, but no response of the engine when we press the throttle.
About press copyright contact us creators advertise developers terms privacy policy & safety how youtube works test new features nfl sunday ticket press copyright. Hello guys i have a 2014 freightliner cascadia 125 with a dd16 engine that it was parked 1 month until today, so i went to parking lot to pick up a load and i realized that. Normally, a similar truck with same specs/engine will. The throttle is non responsive, it takes about 5 seconds and power comes back in increments of 20%, then 40%, then 50%.
Try setting the cruise control at 60. Checked all connections and everything seems to be good. All of a sudden dash board panel stop working and that throttle pedal not working but engine starts okey. Throttle not responding on a series 60.
freightliner cascadia bad cpc4. no start no throttle response flashing
2002 freightliner starts and idles but no throttle at alll.
I then released the parking brakes and managed to get full authority. I got in the truck this afternoon to move it cause i had to get to the trailer behind it and all of a sudden i have no throttle response (only idle) and a yellow check engine light and. Ecm is seeing throttle count but not percent accelerator. I have a 2011 freightliner m2 has 26k miles and i keep getting code 1242 comes and goes randomly.
This is also going to tell you if there is a loss of power or voltage problem before. Swap your relays one at a time with a known good one for testing purposes if you do not have a relay tester. This morning, i put on new batteries and fired right up, but still has a miss and now no throttle response. See if the cruise will catch and maintain the 60 mph set.
freightliner cascadia bad cpc4. no start no throttle response flashing
Truck started having poor/no throttle response recently, especially noticeable when trying to rev up from idle rpms.
I can never get it to do it here, i have replaced the ecm, tcm, throttle. Cruise control works, checked with the computer and found no fault codes. In other instances the truck won't even start, however, the most common failures include a failed throttle control and loss of communication with the instrument cluster which prevents the.
I am working on a Freightliner with a series 60 Detroit. It looses all
