P80 Slide Sticking Back Perfectly But Does Not Rack Engage Firing Pin Or
Slide locked back past the slide lock mechanism and would not move a bit. The hump in the trigger bar is catching on the chamber opening section of the slide and. After my polymer 80 build was complete i took it to the range for the first time.
Gen 4 Glock slide on a P80? Everything you need YouTube
About every 4 or 5 rounds, the slide fails to go back into full battery which then causes a light strike. Well i dry fired it twice and it wouldn’t go into battery, negotiated the slide off and the striker doesn’t move. To release, i removed the back plate on the slide, removed the firing pin assembly and the.
In a pinch you can punch both all 4 of p80 pins out and literally pull the slide off the frame.
If the p80 slide is working on your glock you can be pretty sure the problem is with your build. I checked the trigger reset, and it seemed fine. The end of the spring should stick out towards the rear. You should see the tip.
With the trigger pin you should wiggle. I’ve currently built a p80 g17 with both the frame and slide completed. Popped the backplate off and the sleeve moves around but that pin is rotated to. There are no polymer rail sections that hold the slide to the frame, just the front and real rails which.
Gen 4 Glock slide on a P80? Everything you need YouTube
I bought two p80 complete uppers last black friday sale for half price.
If your p80 slide is not cycling it is often due to the following issues: Mine seemed to get hung up but if i put a little pressure on the rear of the slide it would fall the rest of the way. I had similar issues, back plate rubbed and bound on the trigger housing when the slide went back (wouldn’t go back to battery and i had to strip to unstick it), and the slide and. The slide release spring should curve around the end of the slide release and arc upwards.
I went ahead to disassembly the slide first by pulling the trigger, depress the. I just finished assembling my first p80 g19. Problem fixed itself after a thorough oiling, racking and dry fire, then like 50rds,. I have a slide drag issue but my trigger bar isn't getting hung up on the plunger.
Ported P80 Slide on SCT frame r/polymer80
From first glance i can also see that the slide seems to be a little far back, meaning that there’s a part of the barrel and rod that’s poking out.
When i attach the slide to the. On my g26 build the trigger works and resets fine, but when you pull the slide all the way to the rear it gets stuck just a tiny bit before the slide stop would catch in its notch. However, i’m having some trouble getting the slide to go on correctly.
Polymer 80 Glock 19 Complete Slide Assembly P80PS9CSA
