Over Torque Fault Litter Robot 4 Red & Flashing Yellow

Arm & hammer clump and seal is amongst the heaviest. Purchased as reconditioned from litter robot on line. Using more than 10 lbs (4.5 kg) of litter can strain the motor, causing an over torque fault.

LitterRobot 3 dump position fault, over torque fault 4 by

Red & blue blinking lights: I think it has to have been a new firmware. I followed litter robot's video of taking the globe off, cleaning the.

It stops mid cycle and flashes yellow and red lights.

I already opened it (bonnet and globe), cleaned it and removed most of the litter( same. Here’s what i have done so far: My litter robot 3 recently stopped working. Check for excess litter inside the globe.

I’ve already made sure to not overfill it, even under filled it just to see if it would work and it’s not. Make sure the litter is just below the raised fill line. Some out there use it in their robots and. Explore our support page now.

Details

LitterRobot OverTorque Fault [Simple Guide to Fix]

Does anyone know how to fix an over torque fault?

For the past week, it now has a torque fault and then reverses and repeats this 3 times before returning to home and saying it completed the cycle. The apps says over torque fault. To resolve this issue, please follow the steps in the attached video: Ensured the litter level is at or below the indicated fill line;.

Been goofy for about 2 weeks. I cleaned the sensors too. Is your litter robot 4 showing a red light bar with flashing yellow lights? This usually means the globe is jammed or overloaded.

Details

LitterRobot Over Torque Fault Troubleshooting How to Fix it Quickly

Red & yellow blinking lights:

If none of the steps in the video resolves the issue,. Hello, i am consistently getting over torque errors on my litter robot 3 connect. Support said to take everything apart, clean, and reassemble. Lr 3 connect wont start cycle always telling me its got a over torque fault.

Details

LitterRobot 3 dump position fault, over torque fault 4 by